SR72 – Smart Cream
SR72 WetherDry Smart Cream Nano is an aqueous based hydrophobic impregnating agent based on a mixture of silane and siloxane. SR72 is a high quality speciality product for hydrophobic impregnation of natural mineral substrates.
Brush, Roller or Spray
Concrete ,Brick, stone and renders
100 – 200g per M²
5˚c – 25˚c
Less than 95%
All surfaces should be clean, reasonably dry and free from algae, lichen & other growths and grease. If there is evidence of organic growth, power wash to remove & apply Wethertex C10 Fungicidal wash in accordance with instructions.
SR72 WetherDry Smart Cream is supplied ready to use.
SR72 WetherDry Smart Cream Nano is best applied to the mineral substrate by the airless technique, undiluted and in the desired thickness. Brushes or lambskin roller may be used for smaller areas. Up to 100 – 200 g/m² may be applied in one operation to vertical surfaces without loss of material. The exact amount depends on the absorbency of the substrate.
When stored unopened in a dry place at temperatures above 5oC, shelf life is 12 months from date of manufacture.
All equipment must be washed with clean water immediately after use. Waste material should not be emptied into drainage systems.
HEALTH & SAFETY INSTRUCTIONS
This product contains a biocide for the protection of the cured product. Contains 2-OCTYL-2H-ISOTHIAZOL-3-ONE. May produce an allergic reaction. For further information, please request the material safety data sheet for this product.
The weather conditions for application and drying are critical. Do not apply if any of the following conditions are likely to arise during –
or in the first 24 hours following application:
o If frost is forecast, or in excessive wet conditions
o When Relative Humidity is above 95%
o In temperatures below +5ºC or above +25ºC
o If the elevation is in direct sunlight
o If the substrate is hot (at or above 30C) or below +5ºC
o Coverage rates are approx. and do not take into account wastage and uneven substrates
The render must be protected against heavy rain, direct sun or high wind in the first 24 hours after application. Sheeting the façade or
the scaffold is advised to protect against this. For this particular product, if these parameters are not met, the product is at risk of, efflorescence
and potential failure. It is the responsibility of the application contractor to manage and record the weather conditions during
application and curing of the product.
To the best of our knowledge and belief, this information is true and accurate. However, as conditions of use of the product and the expertise
of any labour involved are beyond our control, the end user must satisfy himself by prior testing that the product is suitable for his
specific application if no spec has been provided for the project in hand. No responsibility can be accepted, nor any warranty given by
our Representatives, Agents or Distributors. Products are sold subject to our Standard Conditions of Sale and the end user should ensure
that he has consulted our latest literature.